FABRICATION AND RESEARCH OF CHARACTERISTICS OF NIO/PPY HYBRID FILMS USED FOR NH3 GAS SENSOR AT ROOM TEMPERATURE

  • Hoang Thi Hien Hung Yen University of Technology and Education
  • Bui Ha Trung Hung Yen University of Technology and Education
Keywords: Hybrid NiO/PPy, vapor phase polymerization

Abstract

This work showed that, the NiO / PPy hybrid films were successfully synthesized by a simple direction from vapor phase polymerization at room temperature and normal pressure. The morphological and structural characteristics of these hybrid films have been examined and compared with the pure PPy and NiO films through SEM image, X-ray diffraction and Fourier-transform infrared spectroscope (FTIR). The measurement results of the initial NH3 gas sensitivity property indicated the response of the NiO/PPy hybrid film is remarkably higher than that of the PPy film without hybridization at room temperture. This research has shown the applied potential in gas sensor at room temperature based on the hybrid material groups between conductive polymers and transition metal oxides.

References

B. Yeole, T. Sen, D. Hansora and S. Mishra, Polypyrrole/Metal Sulphide Hybrid Nanocomposites: Synthesis, Characterization and Room Temperature Gas Sensing Properties. Materials Research, 19, 2016, pp. 999-1007.

M. Joulazadeh and A. H. Navarchian, Ammonia detection of one-dimensional nano-structured polypyrrole/metal oxide nanocomposites sensor. Synthetic Metals, 210, 2015, pp. 404-411.

H. Khan, K. Malook and M. Shah, Highly selective and sensitive ammonia sensor using polypyrrole/V2O5 composites. Journal of Materials Science: Materials in Electronics, 28, 2017, pp. 13873-13879.

S. R. Nalage, A. T. Mane, R. C. Pawar, C. S. Lee and V. B. Patil, Polypyrrole–NiO hybrid nanocomposite films: highly selective, sensitive, and reproducible NO2 sensors. Ionics, 20, 2014, 1607-1616.

P. Singh and S. K. Shukla, A structurally aligned nickel oxide encapsulated polypyrrole nanocomposite for hydrogen peroxide sensing. Dalton Trans, 49, 2020, pp. 8744-8754.

Y. Yu, Y. Xia, W. Zeng and R. Liu, Synthesis of multiple networked NiO nanostructures for enhanced gas sensing performance. Mater. Lett, 206, 2017, pp. 80-83.

H. T. Giang, Nghiên cứu chế tạo cảm biến khí monoxit cacbon và hydrocacbon trên cơ sở vật liệu perovskite ABO3, Luan an tien si, 2013.

H. T. Hien, C. Van Tuan, D. T. Anh Thu, P. Q. Ngan, G. H. Thai, S. C. Doanh, H. T. Giang, N. D. Van and T. Trung, Influence of surface morphology and doping of PPy film simultaneously polymerized by vapour phase oxidation on gas sensing. Synthetic Metals, 250, 2019, pp. 35-41.

Z. Parsaee, Synthesis of novel amperometric urea-sensor using hybrid synthesized NiO-NPs/GO modified GCE in aqueous solution of cetrimonium bromide. Ultrason Sonochem, 44, 2018, pp. 120-128.

K. Mahendraprabhu and P. Elumalai, 2015.

P. Vijayadarshan, T. Mohan, J. V. Viswanath, K. J.Venugopal, N. V. S. Rao and A. Gupta, Large Scale Synthesis of Nickel Oxide (NiO) by Self Propagated Combustion Reaction. Material Science

Research India, 14, 2017, pp. 37-42.

M. N. Siddique, A. Ahmed, T. Ali and P. Tripathi, Investigation of optical properties of nickel

oxide nanostructures using photoluminescence and diffuse reflectance spectroscopy, AIP Conference

Proceedings, 1953 (2018) 030027-030031.

T. P. Mokoena, H. C. Swart and D. E. Motaung, A review on recent progress of p-type nickel oxide based gas sensors: Future perspectives. Journal of Alloys and Compounds, 805, 2019, pp. 267-294.

H. J. Kharat, K. P. Kakde, P. A. Savale, K. Datta, P. Ghosh and M. D. Shirsat, Synthesis of polypyrrole films for the development of ammonia sensor. Polymers for Advanced Technologies, 18, 2007, pp. 397-402.

A. Joshi, S. A. Gangal and S. K. Gupta, Ammonia sensing properties of polypyrrole thin films at room temperature. Sensors and Actuators B: Chemical, 156, 2011, pp. 938-942.

W.-K. Jang, J. Yun, H.-I. Kim and Y.-S. Lee, Improvement of ammonia sensing properties of polypyrrole by nanocomposite with graphitic materials. Colloid and Polymer Science, 291, 2012, pp. 1095–1103.

S. G. Bachhav and D. R. Patil, Study of Polypyrrole-Coated MWCNT Nanocomposites for Ammonia Sensing at Room Temperature. Journal of Materials Science and Chemical Engineering, 03, 2015, pp. 30-44.

P. Patil, G. Gaikwad, D. R. Patil and J. Naik, Gas Sensitivity Study of Polypyrrole Decorated Graphene Oxide Thick Film. Journal of The Institution of Engineers (India): Series D, 97, 2016, pp. 47-53.

J. Zhang, X. Liu, S. Wu, x. Hongyan and B. Cao, One-pot fabrication of uniform polypyrrole/Au nanocomposites and investigation for gas sensing. Sensors and Actuators B: Chemical, 186, 2013, pp. 695-700.

Y. Li, M. Jiao and M. Yang, In-situ grown nanostructured ZnO via a green approach and gas sensing properties of polypyrrole/ZnO nanohybrids. Sensors and Actuators B: Chemical, 238, 2017, pp. 596-604.

H. Tai, Y. Jiang, G. Xie, J. Yu and M. Zhao, Self-assembly of TiO2/polypyrrole nanocomposite ultrathin films and application for an NH3 gas sensor. International Journal of Environmental Analytical Chemistry, 87, 2007, pp. 539-551.

Y. Wu, S. Xing and J. Fu, Examining the Use of TiO2 to Enhance the NH3 Sensitivity of Polypyrrole Films. Journal of Applied Polymer Science - J APPL POLYM SCI, 118, 2010.

T. A. Ho, T.-S. Jun and Y. S. Kim, Material and NH3-sensing properties of polypyrrole-coated tungsten oxide nanofibers. Sensors and Actuators B: Chemical, 185, 2013, pp. 523-529.

H. A. Khorami, A. Eghbali, M. Keyanpour-Rad, M. R. Vaezi and M. Kazemzad, Ammonia sensing properties of (SnO2–ZnO)/polypyrrole coaxial nanocables. Journal of Materials Science, 49, 2014, pp. 685-690.

Published
2022-03-09
How to Cite
Hoang Thi Hien, & Bui Ha Trung. (2022). FABRICATION AND RESEARCH OF CHARACTERISTICS OF NIO/PPY HYBRID FILMS USED FOR NH3 GAS SENSOR AT ROOM TEMPERATURE. UTEHY Journal of Science and Technology, 31, 14-20. Retrieved from https://tapchi.utehy.edu.vn/index.php/jst/article/view/471